Site, online access to ASTM's journal for which the Subscriber maintains a current Measures necessary to ensure that the Subscriber's IP addresses are not used toĪccess the journals other than by authorized Users.ĪSTM International grants to the Subscriber and Authorized The Subscriber will be responsible for all access control and security This ASTM Document may not otherwise be sold or resold, rented, leased, lent or The single hard copy print may only be distributed to otherĮmployees for their internal use within your organization it may not be copied. That is, the electronic file cannot be e mailed, downloaded to disk, copied to another hardĭrive, or otherwise shared. In addition, the electronic file may not be distributed elsewhere over computer networks or Neither the electronic file nor the single hard copy print may be reproduced in any way. The right to download an electronic file of this ASTM Document for temporary storage on oneĬomputer for purposes of viewing, and/or printing one copy of the ASTM document You may not remove or obscure the copyright notice or other notices contained in the ASTMĪSTM grants you a limited, non-transferable license as follows: This is not a sale all right, title and interest in the ASTM Document (in both electronic file You (Licensee) have no ownership or other rights in the ASTM Document. This document is copyrighted by the ASTM International (ASTM), 100īarr Harbor Drive, West Conshohocken, PA 19428-2959 USA.Īll rights reserved. Please click here to view License Agreement for Educational Institutions. If you do not agree to the terms of this License Agreement, promptly exit this page This License Agreement, that you understand it and that you agree to be bound by its IMPORTANT-READ THESE TERMS CAREFULLY BEFORE DOWNLOADING THIS DOCUMENT.īy downloading the ASTM Document you are entering into a contract, and acknowledge that Viscosity values not listed but which are within the range given in Table I may be obtained by linear interpolation. The Saybolt Viscosity values obtained from this Table, following the reporting procedure outlined in the Standard Method of Test for Saybolt Viscosity (ASTM Designation: D 88, should be reported to the nearest 0.1 sec for viscosity values below 200 sec and to the nearest whole second for values 200 sec or above. These kinematic viscosity values are based upon the standard value for distilled water of 1.0038 cs at 68 F and are given in increments smaller than are officially measured by, or reported for the Saybolt Universal Viscometer. The viscosity conversion values in this table have been calculated in accordance with the Standard Method for Conversion of Kinematic Viscosity to Saybolt Universal Viscosity (ASTM Designation: D 446). The relationship between Saybolt and kinematic viscosities is linear above 20.0 cs. Conversion values are given for a range of kinematic viscosity from 1.77 to 500 cs. This table gives values for converting kinematic viscosity in centistokes to Saybolt Universal viscosity in seconds at 100 F and at 210 F.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |